Tuning Mpls Te Tunnel Setup; Configuring Loop Detection; Configuring Route And Label Recording; Configuring Tunnel Setup Retry - HP 10500 SERIES Configuration Manual

Tuning MPLS TE tunnel setup

This section only covers the configuration tasks for tuning MPLS TE tunnel setup.
You must use the configurations described in this section together with a dynamic signaling protocol
(such as RSVP-TE). Before performing the configuration tasks, be aware of each configuration objective
and its impact on your system.

Configuring loop detection

Step
1. Enter system view.
2. Enter MPLS TE tunnel interface view.
3. Enable the system to perform loop
detection when setting up a tunnel.
4. Submit current tunnel configuration.

Configuring route and label recording

Step
1. Enter system view.
2. Enter MPLS TE tunnel interface
view.
3. Enable the system to record
routes or labels when setting
up the tunnel.
4. Submit
configuration.

Configuring tunnel setup retry

You can configure the system to attempt setting up a tunnel multiple times until it is established
successfully or until the number of attempts reaches the upper limit.
To configure tunnel setup retry:
Step
1. Enter system view.
2. Enter MPLS TE tunnel interface
view.
3. Configure maximum number
of tunnel setup retries.
Command
system-view
interface tunnel tunnel-number
•
Record routes:
mpls te record-route
•
Record routes and labels:
mpls te record-route label
current tunnel
mpls te commit
Command
system-view
interface tunnel tunnel-number
mpls te retry times
Command
system-view
interface tunnel tunnel-number
mpls te loop-detection
mpls te commit
113
Remarks
N/A
N/A
Disabled by default.
N/A
Remarks
N/A
N/A
Use either command.
Both route recording and label
recording are disabled by default.
N/A
Remarks
N/A
N/A
Optional.
The default is 10.