Configuring The Maximum Number Of Attempts Made To Retry A Connection; Configuring The Close-Wait Timer Of The Cpe - HP MSR Series Configuration Manual
Msr router series network management and monitoring
Hide thumbs
Also See for MSR Series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Enter CWMP view.
3.
Enable the periodic sending
of Inform messages.
4.
Configure the interval
between sending the Inform
messages.
To configure the CPE to send an Inform message at a specific time:
Step
1.
Enter system view.
2.
Enter CWMP view.
3.
Configure the CPE to send an
Inform message at a specific
time.
Configuring the maximum number of attempts made to retry a
connection
If a CPE fails to establish a connection to an ACS or the connection is interrupted during the session (the
CPE does not receive a message indicating the normal close of the session), the CPE can automatically
reinitiate a connection to the ACS.
To configure the maximum number of attempts that the CPE can make to retry a connection:
Step
1.
Enter system view.
2.
Enter CWMP view.
3.
Configure the maximum
number of attempts that the
CPE can make to retry a
connection.
Configuring the close-wait timer of the CPE
The close-wait timer is used mainly in the following cases:
During the establishment of a connection, if the CPE sends a connection request to the ACS, but the
•
CPE does not receive a response within the configured close-wait timeout, the CPE considers the
connection as having failed.
•
After a connection is established, if there is no packet interaction between the CPE and the ACS
within the configured close-wait timeout, the CPE considers the connection to be invalid and
disconnects the connection.
Command
system-view
cwmp
cwmp cpe inform interval enable
cwmp cpe inform interval seconds
Command
system-view
cwmp
cwmp cpe inform time time
Command
system-view
cwmp
cwmp cpe connect retry times
81
Remarks
N/A
N/A
By default, this function is disabled.
Optional.
By default, the CPE sends an Inform
message every 600 seconds.
Remarks
N/A
N/A
By default, no time is set. The CPE
is not configured to send an Inform
message at a specific time.
Remarks
N/A
N/A
Optional.
By default, the CPE regularly sends
connection requests to the ACS
until a connection is set up.
Advertisement
Table of Contents
Troubleshooting
