To configure the priority of a port or a group of ports:
Step
1.
Enter system view.
2.
Enter interface view or
port group view.
3.
Configure the port
priority.
Configuring the port link type
A point-to-point link directly connects two devices. If two root ports or designated ports are connected
over a point-to-point link, they can rapidly transit to the forwarding state after a proposal-agreement
handshake process.
Configuration restrictions and guidelines
You can configure the link type as point-to-point for a Layer 2 aggregate interface or a port that
•
operates in full duplex mode. HP recommends you to use the default setting and let the device to
automatically detect the port link type.
The stp point-to-point force-false or stp point-to-point force-true command configured on a port in
•
MSTP mode take effect on all MSTIs.
•
If the physical link to which the port connects is not a point-to-point link but you set it to be one, the
configuration might cause temporary loops.
Configuration procedure
To configure the link type of a port or a group of ports:
Step
1.
Enter system view.
2.
Enter interface view or
port group view.
3.
Configure the port link
type.
Command
system-view
•
Enter Ethernet interface view or Layer 2
aggregate interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
•
In STP/RSTP mode:
stp port priority priority
•
In MSTP mode:
stp [ instance instance-id ] port priority
priority
Command
system-view
•
Enter Ethernet interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual port-group-name
stp point-to-point { auto | force-false |
force-true }
66
Remarks
N/A
Use one of the commands.
Use one of the commands.
The default setting is 128.
Remarks
N/A
Use one of the commands.
By default, the link type is auto
and the port automatically
detects the link type.