Step.6:.Mount.the.unit - Proxim AP-4000MR-LR Quick Install Manual

step 6: Mount the unit
If.the.AP.is.going.to.be.used.as.part.of.a.Mesh.network,.you.will.need.to. If.the.AP.is.going.to.be.used.as.part.of.a.Mesh.network,.you.will.need.to.
perform initial configuration of the parameters mentioned in the Prereq- perform initial configuration of the parameters mentioned in the Prereq-
uisites.section.of.this.AP-4000MR-LR User Guide.before.you.mount.the. uisites.section.of.this.AP-4000MR-LR User Guide.before.you.mount.the.
AP. See the User Guide for more information on configuring these param- AP. See the User Guide for more information on configuring these param-
eters. eters.
Caution:
To.ensure.that.water.does.not.gather.around.the.antenna.
connectors,.mount.the.unit.with.the.antenna.connectors.facing.
downward.
1. To.pole-mount,.insert.screws.through.bracket.F.and.fasten.around.pole.to.
bracket.E.and.secure.(Torque.11.N . m/100.in-lbs).
2. To.wall-mount.the.unit,.mount.bracket.(E).to.wall.using.4.screws.(not.
provided),.as.shown:
Note:.
At.the.end.of.the.installation,.the.Ethernet.and.serial.ports.must.be.made.
waterproof.by.installing.the.caps...Be.careful.not.to.over-tighten.the.caps.as.
damage.to.the.cable.may.occur.
All rights reserved
IMPORTANT! IMPORTANT!
Page 17