Table of Contents
Advertisement
Installation
Mounting Instructions
The Harmony 802.11a Access Point ships with a wall mounting kit so that the unit can
be mounted to a wall or ceiling.
The wall mounting kit contains the following parts:
•
One AP Mounting Disk
•
Two Plastic Wall Mount Anchors
•
Two #6x0.75" Wood Screws
In addition, you will also need the following tools to wall mount the Access Point:
•
3/16" Drill (for installations using wall mount anchors)
•
Marking Pen
•
Phillips Screwdriver
Ceiling Mount
Follow these steps to mount the Harmony 802.11a Access Point on the T-bar that
separates office ceiling tiles:
1.
Slide the AP Mounting Disk over a ceiling tile's T-bar so the bar rests between the
two clips on the mounting disk, as shown in the illustrations below.
Ceiling T-Bar
Figure 3: Attaching the AP Mounting Disk to a Ceiling T-Bar
Figure 4: AP Mounting Disk Secured to Ceiling T-Bar
Mounting clips
14
Advertisement
Table of Contents
