Step 6: Mount The Unit - Proxim AP-4900MR-LR Quick Install Manual

step 6: Mount the unit

If the AP is going to be used as part of a Mesh network, you will need to If the AP is going to be used as part of a Mesh network, you will need to
perform initial configuration of the parameters mentioned in the Prereq- perform initial configuration of the parameters mentioned in the Prereq-
uisites section of this AP-4900MR-LR User Guide before you mount the uisites section of this AP-4900MR-LR User Guide before you mount the
AP. See the User Guide for more information on configuring these param- AP. See the User Guide for more information on configuring these param-
eters. eters.
Caution:
To.ensure.that.water.does.not.gather.around.the.antenna.
connectors,.mount.the.unit.with.the.antenna.connectors.facing.
downward.
1. To pole-mount, insert screws through bracket F and fasten around pole to
bracket E and secure (Torque 11 N . m/100 in-lbs).
2. To wall-mount the unit, mount bracket (E) to wall using 4 screws (not
provided), as shown:
Note:.
At the end of the installation, the Ethernet and serial ports must be made
waterproof by installing the caps. Be careful not to over-tighten the caps as
damage to the cable may occur.
All rights reserved
IMPORTANT! IMPORTANT!
Page 17