Other Services For Offline And Online Mode; Comparing Iparameter Sets; Change Password - WAGO 8FDI 24V PROFIsafe 750-662/000-004 Manual

WAGO I/O System
750-662/000-004 8FDI 24V PROFIsafe
To print the iParameter values and the information on the parameter file, click the
[Print] button in the WAGO Safety Editor toolbar.
7.3.3

Other Services for OFFLINE and ONLINE Mode

7.3.3.1

Comparing iParameter Sets

WAGO Safety Editor provides additional services. Click the [Services] button in
the WAGO Safety Editor toolbar. A selection menu appears with the Compare
menu item.
Comparison of iParameter settings
This function can only be used to compare iParameter settings with the same F
I/O module type and iParameter set format.
To compare two iParameter sets with each other, select the Compare menu
item. The Comparison of iParameter Sets dialog opens.
To load a parameter file saved on the computer for comparison, click the [Open]
button and specify whether the iParameter set should appear in the "Reference"
or "Comparison" column.
To load the iParameter settings from the F I/O module that is currently connected
for comparison in ONLINE mode, click the [Read] button and specify whether the
iParameter set should appear in the "Reference" or "Comparison" column.
To reset the comparison dialog to its original state, click the [Delete] button.
To print the results of the comparison between to iParameter sets, click the
[Print] button.
To exit the WAGO Safety Editor comparison dialog, click the [Close] button.
To close WAGO Safety Editor, click the [Exit] button in the WAGO Safety Editor
toolbar.
7.3.3.2

Change Password

Changing the password
Use this function to reset the current password of an F I/O module.
To change the password, select the Password menu item.
If you have not assigned a password to the selected F I/O module, you can
specify a password in the Change F I/O Module Password dialog.
Version 1.0.0, valid from HW/SW Version 01/01
Commissioning 55
Manual