WAGO I/O System
750-662/000-004 8FDI 24V PROFIsafe
7.3.4.2
Direct Start from the Operating System
Launch WAGO Safety Editor.
WAGO Safety Editor starts in OFFLINE mode.
7.3.4.3
Indirect Start via WAGO-I/O-CHECK from the Configuration Program
(Device Level TCI Conformance Class 2)
In the configuration program of the safe PLC, select a device (fieldbus coupler)
and launch WAGO-I/O-CHECK via the "WAGO-I/O-CHECK 3" TCI link. The
configuration program passes the current language and communication setting to
WAGO-I/O-CHECK.
Select an F I/O module for parameterization from the fieldbus node configuration
displayed in WAGO-I/O-CHECK. WAGO-I/O-CHECK then starts WAGO Safety
Editor 75x with the current language and communication settings. WAGO Safety
Editor starts in ONLINE mode.
The communication is performed via ETHERNET TCP/IP.
If you exit the configuration of the F I/O module and close Safety Editor, WAGO-
I/O-CHECK also closes.
7.3.4.4
Indirect Start via WAGO-I/O-CHECK from the Configuration Program
(Module Level TCI Conformance Class 2)
In the configuration program, select an F I/O module and launch WAGO-I/O-
CHECK via the "WAGO-I/O-CHECK 3" TCI link. The configuration program
passes the current language and communication setting to WAGO-I/O-CHECK.
WAGO-I/O-CHECK then starts WAGO Safety Editor 75x with the current
language and communication settings. WAGO Safety Editor starts in ONLINE
mode.
The communication is performed via ETHERNET TCP/IP.
If you exit the configuration of the F I/O module and close WAGO Safety Editor,
WAGO-I/O-CHECK remains open.
7.3.4.5
Direct Start from the Configuration Program (Module Level TCI
Conformance Class 3 ONLINE)
In the configuration program of the safe PLC, select an F I/O module and launch
WAGO Safety Editor 75x via the "WAGO Safety-Editor 75x" TCI link. The
configuration program passes the current language and communication setting to
WAGO Safety Editor. WAGO Safety Editor starts in ONLINE mode.
Communication is performed via PROFINET.
7.3.4.6
Direct Start from the Configuration Program (Device Level TCI
OFFLINE)
In the configuration program of the safe PLC, select a device (fieldbus coupler)
and launch WAGO Safety Editor 75x via the "WAGO Safety-Editor 75x" TCI link
Version 1.0.0, valid from HW/SW Version 01/01
Commissioning
57
Manual