Figure 19: Serial Connection With Pc For Cli Communication - AudioCodes Mediant 1000B MSBR Hardware Installation Manual

Note: Orderable RS-232 cable adapter:
•
Conductive 30 (7/0.1)x3C, Tinned copper wire. PVC Coating dia=0.7mm, Color black.
Shield: AL (MAYLER)+BRAID (16/4/0.12) Tinned copper wire, coverage 90% min.
Assembly cotton paper. Jacket PU (4485AF), dia=3.5mm.
•
Conductive 30 (7/0.1)x6C, Tinned copper wire. PVC Coating dia=0.6mm, Color black.
Shield: AL (MAYLER)+BRAID (16/4/0.12) Tinned copper wire, coverage 90% min.
Filler cotton yarn. Assembly cotton paper. Jacket PU (4485AF), dia=4mm.
•
Operation Temp: -10 c ->+80 c
•
Insulation resistance: DC/100V 5M OHM MIN.
•
Withstand Voltage: AC/250V 2mA, for one minute.
•
Continuity test: 100%.
•
RoHS Note: All materials composing this item should comply with the requirements of
directive 2002/95/ec on the restriction of the use of certain hazardous substances in
electrical and electronic equipment
•
UL Note: Cable components according to UL standard.

To connect the serial interface port to a computer:
1. Connect the flat connector (labeled "P3" in the figure above) to the serial port (labeled
1010) on the device's CRMX module.

Figure 19: Serial Connection with PC for CLI Communication

2. Connect the DB-9 connector labeled "P1" (red) to the COM1 or COM2 RS-232
communication port of your computer.
Notes:
•
The RS-232 port is not intended for permanent connection.
•
The DB-9 connector labeled "P2" is used only for debugging.
Hardware Installation Manual 48
Mediant 1000B MSBR
Document #: LTRT-40881