ABB IRB 4400 - 45 Product Manual page 280

6 Reference information
6.8. Special tools
Continued
Lifting tool
The table below specifies the lifting tools required during several of the service procedures.
The tools may be ordered separately and are also specified directly in concerned instructions
in the Product manual, procedures.
Description
Lifting tool
Hoisting block
Lifting chain (used together with the hoisting
block)
Support, base and gear axis 1
Lifting tool, gearbox axis 1
Lifting eye (used together with lifting tool
3HAC 15556-1)
Lifting tool, gearbox
Guide pins, M12x130
Guide pins, M16x
Lifting eye, M16
Lifting eye, M20
Crank
Lifting tools
The table below specifies the lifting tools required during several of the service procedures.
The tools may be ordered separately and are also specified directly in concerned instructions
in the
Description
Lifting tool, tilt house
Lifting tool, lower arm + balancing weight
Lifting tool, lower arm
Lifting tool, motor
Lifting tool, gear ax.2
Lifting tool, frame
Lifting tool, complete robot
Lifting tool, parallel arm
Lifting tool, turning device gearbox ax.1
Lifting tool, base
Guide pin, (short)
Guide pin, (long)
278
Product manual, procedures.
Qty Art. no.
3HAC 026597-001
3HAC15535-1
3HAC 15556-1
3HAC 025333-005
3HAC 025214-001
3HAC 022637-001
3HAC 14457-1
Qty Article no.
3HAC 023154-001
3HAC 8446-1
3HAC 8445-1
3HAC 14586-1
3HAC 023240-001
3HAC 023308-001
3HAC 15607-1
3HAC 023098-001
3HAC 14406-1
3HAC 14868-1
3HAC 7601-086
3HAC 7601-087
Continues on next page
3HAC022032-001 Revision: E