ABB IRB 4400 - 45 Product Manual page 273

C
D
E
F
Dismounting tool, tilthouse shaft
The tool for removing the tilthouse shaft from the tilthouse is assembled with the parts shown
in the figure below (included in the toolkit for service).
Note! The parts cannot be ordered separately, but are included in the complete toolkit! The
article numbers are only given for identification.
xx0600002589
A
B
C
D
E
F
G
J
3HAC022032-001 Revision: E
Mounting tool, bearing race and sealing, upper arm. Assembly is shown in the
figure Mounting tool, bearing race and sealing, upper arm on page
Dismounting tool, bearing race, upper arm. Assembly is shown in the figure
Dismounting tool, bearing race, upper arm on page
Press tool, link. Assembly is shown in the figure
Press sleeve, art. no. specified in the table
Hydraulic cylinder, 3HAC11731-1
Press washer, 3HAC023963-007
Hex socket head cap screw, 9ADA183-25, 2 pcs, M6 x 25
Connection rod, M16, length= 400 mm
Nut, 3HAC5507-1
Sleeve, 3HAC023963-027
Nut, 3HAC023963-028
Pad, 3HAC023963-029
6 Reference information
6.8. Special tools
273.
273.
Press tool, link on page
Special tools on page 269.
Continues on next page
Continued
276.
271