Vertical Shaft Disassembly; Assembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead
Set a wood block [1] under the reverse bevel gear [2].
Apply gear oil to the circumference of a new needle
bearing [3].
Drive the needle bearing into the propeller shaft holder
[4] using the special tools and a hydraulic press as
shown.
• Install the needle bearing with the stamped side
toward the special tools.
TOOLS:
Driver [5]
Attachment, 37 x 40 mm [6]
Pilot, 30 mm [7]

VERTICAL SHAFT DISASSEMBLY/

ASSEMBLY

DISASSEMBLY
Remove the oil slinger [1] from the vertical shaft [2] by
expanding the cut in the oil slinger with a screwdriver
[3].
[4]
07749-0010000
07746-0010200
07746-0040700
[3]
[1]
GEAR CASE
[3]
[2]
[5]
[6]
[7]
[2]
[1]
16-33