dummyhead
dummyhead
CYLINDER HEAD
CYLINDER HEAD ASSEMBLY/DISASSEMBLY
DISASSEMBLY
• Mark the removed parts (e.g. valves, springs, and
other related parts) and store them securely,
grouping them by intake side and exhaust side for
each cylinder. Install each part in the original
position on the assembly.
Remove the following:
– Cylinder head (page 14-19)
– Water jacket (page 11-4)
– Oil pump (page 12-7)
– VTEC solenoid valve (page 5-82)
– ECT sensor 3 (page 5-85)
– CMP sensor (page 5-83)
– HO2S (page 5-82)
Loosen the rocker arm lock nut [1], and loosen the
adjusting screw [2] fully.
Loosen the five rocker shaft bolts [1] in the numbered
sequence shown in two or three steps.
Remove the five rocker shaft bolts [1]. Remove the
rocker shaft assembly [2] and dowel pin [3].
• Bundle the rocker arm assembly of each cylinder
with a strap [4] during removal of the rocker shaft
assembly.
Remove the four lost motion springs [5] from the
cylinder head assembly.
14-22
[1]
[2]
[1]
3.
5.
2.
[2]
[4]
[5]
1.
4.
[1]
[3]