TOHATSU BFT75A Service Manual page 578

dummyhead dummyhead
Connect the connectors to the indicator light connectors [1], combination switch connectors [2], and warning
buzzer connectors [3].
Set tube A [4] over the connectors that were just connected, and clamp tube A at the connectors securely using
a new harness band clip [5].
After clamping with the harness band clip, cut off the excess band at 15 – 20 mm (0.6 – 0.8 in) from the fastener
end.
• Do not set the Black connector [6] of the combination switch connector in tube A.
[2]
[6]
[3]
Set the connectors [1] in the cord tube (40 mm) [2] and
clamp the tube using a new harness band clip [3] as
shown.
After clamping with the harness band clip, cut off the
excess band at 15 – 20 mm (0.6 – 0.8 in) from the
fastener end.
[5]
[1]
[1]
CONTROLS
[5]
15 – 20 mm
(0.6 – 0.8 in)
[4]
[3]
19-41
[2]