TOHATSU BFT75A Service Manual page 212

dummyhead dummyhead
INSTALLATION
Install the new intake manifold gasket [1] on the intake
manifold.
• Align the projection [2] of the gasket with the groove
[3] in the intake manifold.
Set the intake manifold [1] on the engine.
Install the three bolts [2], two bolt/washers [3], and the
two nuts [4], and tighten them in the numbered
sequence shown in two or three steps.
Install the new gasket [1] on the intake manifold.
Install the throttle body [2]. Tighten the four bolts [3] to
the specified torque in the numbered sequence shown
in two or three steps.
TORQUE:
Install the throttle rod [4].
• Do not loosen the throttle rod.
Connect the IAC valve 2P connector [1], and EOP
sensor 3P connector [2].
Install the two harness band clips [3] in the position
shown.
22 N·m (2.2 kgf·m, 16 lbf·ft)
[2]
[3]
[1]
2.
[3]
3.
[2]
[2]
[3]
4.
1.
2.
3.
[4]
[1]
[1]
[3]
FUEL SYSTEM
[1]
6.
4.
1.
[4]
5.
7.
[2]
5-71