7) Disassembly of Propeller Shaft Ass'y
Push small bladed screw driver into clutch pin snap 1 to
1.
remove it while rotating propeller shaft. Then, push clutch pin
2 lightly while apply preload to push rod 4 to pull out the
pin. Remove clutch 3, push rod 4, spring retainer 5, and
spring 6.
• Take care not to allow ball fly out by easing
spring tension gradually.
• Do not reuse removed clutch pin snap.
Check clutch 3, spring retainer 5, ball, and push rod 4 for
2.
crack and wear. Replace if necessary.
8) Inspection of Propeller Shaft
1.
Check propeller shaft for bend and wear. Replace if
necessary.
2.
Measure cam shaft runout.
Runout Limit :
0.05 mm ( 0.0020 in )
9) Assembly of Propeller Shaft Ass'y
Attach spring 6, spring retainer 5, ball, push rod 4, clutch
1.
3 and clutch pin 2 to propeller shaft.
• Install clutch with groove a facing push rod
side.
• Install clutch pin while applying preload to push
rod.
• Be careful not to allow ball to fly out by spring
tension.
Attach new clutch pin snap 1 by using a small bladed screw
2.
driver to turn the snap spirally.
Do not reuse removed clutch pin snap.
25/30 2006
CAUTION
1
2
3
6
1
5
4
2
a
a Supporting Points
3
6
1
5
4
2
4
6
a
FWD
a
6-11