Water Separator Disassembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead
Connect fuel tube A [1] to the
[2] of the joint of the water separator.
Connect fuel tube B [3] to the
[4] of the joint of the water separator, aligning the "I"
mark [5] on fuel tube B with the
separator.
Install tube clip B12 [6] with the lugs up.
After connecting the fuel tubes, check for gasoline
leaking from the joints.
Install the water separator on the relay bracket [7]
Install the engine cover.
WATER SEPARATOR DISASSEMBLY/ASSEMBLY
Remove the water separator (page 5-87).
mark (suction side)
mark (discharge side)
mark on the water
SCREW (5 X 12 mm) (3)
3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
BAFFLE PLATE
WATER SEPARATOR BODY
[1]
[5]
[3]
PLATE
WATER SEPARATOR
CUP/WATER LEVEL
SENSOR
FUEL SYSTEM
[2]
[4]
[6]
[7]
O-RING
5-89