TOHATSU BFT75A Service Manual page 575

dummyhead dummyhead
CONTROLS
Apply marine grease to the grip pipe installation part of
the tiller handle.
Install the throttle friction block [1] on the tiller handle by
aligning the wide projection [2] on the tiller handle with
the wide recess [3] in the friction block.
Apply marine grease to the outer surface of the throttle
cable pin [1].
Install the throttle cable pin on the throttle cable pivot so
that the pin ends protrude from the throttle cable pivot
by the dimensions shown.
Apply marine grease to the inner wall of the grip pipe
[1], circumference of the throttle friction pad [2].
Install the throttle friction pad on the grip pipe.
Install the grip pipe on the tiller handle by turning the
grip pipe counterclockwise slowly.
Tighten the throttle friction grip [3] against the throttle
friction block [4], aligning the recess [5] in the throttle
friction pad with the projection [6] on the throttle friction
block.
19-38
[1]
[3]
[2]
3 mm (0.12 in)
7 mm (0.28 in)
[6]
3 mm (0.12 in)
[1]
[5]
[2]
[3]
[1]
[4]