TOHATSU BFT75A Service Manual page 58

dummyhead dummyhead
LEAD WIRE
• Route between the lugs of the anode
metal.
• Install so that the angle is 90° as
shown at the power trim/tilt side.
WIRE
HARNESS CLIP
(Except LHGX type)
POWER TILT MOTOR
(Except LHGX type)
• Install by aligning the lower edge of the tape
with the motor wire bushing.
• Wrap the spiral tube by aligning the lower
edge with the upper edge of the tape on the
power tilt motor wire.
SPIRAL TUBE
(12 X 14.6 mm)
(Except LHGX type)
TAPE
MOTOR WIRE GROMMET
(Except LHGX type)
SERVICE INFORMATION
POWER TRIM/TILT
90°
LUG
TRIM ANGLE
SENSOR WIRE
(Except LHGX type)
POWER TILT
MOTOR WIRE
(Except LHGX type)
ANODE METAL
CORRUGATE TUBE
(Except LHGX type)
2-39