TOHATSU BFT75A Service Manual page 234

dummyhead dummyhead
FUEL PUMP ASSEMBLY
Install new O-rings [1] on the vapor separator body.
Install the pump case [2] with care not to allow the O-
rings to come out of position.
Set the bracket [3] on the bolt [4].
TORQUE:
Install tube clamp B [5] and grommet [6] on the bracket.
Connect the vinyl [7] tube to the pump case.
Apply engine oil to new O-ring [8], and install it on the
drain screw [9].
Tighten the drain screw to the specified torque.
TORQUE:
Install the ring [1] to the fuel pump (high pressure side)
[2].
Install the fuel pump (high pressure side) on the
insulator [3].
• Install by aligning the projection [4] on the pump with
the hole [5] in the insulator.
Apply engine oil to a new O-ring [1], and install it on the
fuel pump/insulator [2].
Install the fuel pump/insulator on the pump case [3]. Be
sure to install it the direction shown.
11.8 N·m (1.2 kgf·m, 9 lbf·ft)
1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
[1]
[2]
[9]
[8]
[7]
[4]
[2]
[1]
[5]
[1]
[3]
[3]
FUEL SYSTEM
[5]
[6]
[3]
[4]
[3]
[2]
5-93