TOHATSU BFT75A Service Manual page 303

dummyhead dummyhead
STARTING SYSTEM
Install the spring [1] and plunger [2] to the starter
solenoid [3], then assemble the plunger and clutch fork
[4] as shown.
Install and tighten the two screws [5].
Connect the motor wire [6] to the M terminal [7] and
tighten the nut [8].
WATER RESISTING SEALANT
APPLICATION POINTS
After the assembling the starter motor, apply a sufficient
amount of water-resisting sealant (Sumitomo 3M
Padding Sealer #8533 or equivalent) to the mating
surfaces as shown.
– Packing/front bracket mating section [1]
– Starter solenoid/front bracket mating section [2]
– Starter solenoid mounting screw [3]
– Screw/ bolt and rear bracket mating sections [4]
– Wire grommet and rear bracket [5]
– Engagement sections with yoke [6]
– Starter solenoid case caulking section [7]
9-18
[4]
[5]
[7]
[4]
[6]
[1]
[3]
[1]
[2]
[2]
[8]
[6]
[1]
[7]
[5]
(7)
[2]
[3]