dummyhead
dummyhead
EXPLODED VIEW
ALTERNATOR ROTOR
BOLT (6 X 14 mm)
HARNESS
BAND CLIP E
O-RING
CKP SENSOR
BOLT (6 X 16 mm)
INSTALLATION
Install the alternator stator [1] on the chain case by
aligning part A [2] of the alternator stator with the recess
[3] in the chain case as shown.
Install the three bolts [1] and tighten them.
CHARGING SYSTEM
BOLT/WASHER (14 X 36 mm)
Tighten the bolt in 3 steps:
1. Torque to 187 N·m (19.1 kgf·m,
138 lbf·ft) to seat the alternator rotor,
and then loosen the bolt.
2. Torque to 37 N·m (3.8 kgf·m,
27 lbf·ft).
3. Tighten an additional 90°.
BOLT (6 X 32 mm) (3)
ALTERNATOR
STATOR
[2]
[1]
[1]
[3]
7-9