TOHATSU BFT75A Service Manual page 576

dummyhead dummyhead
Install and tighten the bolt [1] to the specified torque.
TORQUE: 7 N·m (0.71 kgf·m, 5.2 lbf·ft)
Check that the grip pipe is tightened securely by turning
it clockwise fully (full close position), and tighten the
throttle friction grip securely.
Install the grip rubber [2] on the grip pipe with the "
mark [3] facing up.
After installing the grip rubber [1], operate the throttle
grip and check that the "
aligns with the fully open position or full close position
(" " mark) [3] of the throttle mark.
If not, remove the grip rubber and install it again.
"
" mark [2] on the grip rubber
[3]
[2]
[2]
[1]
CONTROLS
[1]
[3]
19-39