Assembly - TOHATSU BFT75A Service Manual

dummyhead dummyhead

ASSEMBLY

Install the lock plate [1] on the spring guide [2].
Install and tighten the two screws [3].
Apply marine grease to the outer surface of the spring
[4], shift arm pin [5], and the roller [6].
Install the shift arm pin and spring on the spring guide
by noting the shift arm pin installation direction as
shown.
Apply marine grease to the outer surface of the bushing
[7], and install it on the shift frame [8].
Apply marine grease to the shift gear [9] in the positions
shown.
Install the roller of the spring guide on the roller
installation part of the shift gear as shown.
Apply marine grease to the gear [10] of the arm [11] of
the shift frame.
Set the shift frame so that the arm is at right angles to
the horizontal line as shown.
Install the shift gear/spring guide assembly on the shift
frame with care not to move the arm of the shift frame.
• If the arm of the shift frame moved, remove the shift
gear/spring guide assembly once and install them
again.
Install and tighten the two screws [12] on the shift
frame.
Apply marine grease to the sliding surface of the throttle
cable pivot [1].
Apply marine grease to the sliding surface of the throttle
rod [2].
Install the rod grommet [3] on the throttle rod and
Tighten the nut [4] on the throttle rod.
Tighten the throttle cable pivot on the throttle rod.
[3]
[5]
[4]
[6]
[9]
[7]
[8]
[5]
[6]
[9]
[2]
[10]
[4]
[1]
CONTROLS
[1]
[2]
[12]
[11]
UP
[1]
[4]
[11]
[8]
[3]
[2]
19-35