Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead

INSTALLATION

Apply soapy water to the outer circumference of the
new water seals (23 x 36 x 6 mm) [1].
Drive the water seals (23 x 36 x 6 mm) one by one into
the water pump housing using the special tools.
Note the installation direction of the water seals.
Be sure to apply marine grease to the water seal mating
surfaces before installation.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Apply marine grease to the water seal lips.
Install the rubber setting plate [1] and gear case
grommet [2] in the gear case.
Apply marine grease to the circumference of new water
pump housing O-ring [3] and install it on the water
pump housing [4].
Install the new water pump gasket [5] and water pump
housing on the gear case.
Install the two dowel pins [6] in the water pump housing.
07749-0010000
07746-0010100
[2]
COOLING SYSTEM
WATER SEAL
INSTALLATION
DIRECTION:
GEAR CASE SIDE
[1]
[3]
[6]
[4]
[3]
[5]
[2]
[1]
11-9