TOHATSU BFT75A Service Manual page 315

dummyhead dummyhead
OTHER ELECTRICAL
Remove the ECM (page 10-3)
Release the fuse box 5P connector [1] from the ECM
bracket [2] and disconnect the 5P connector.
Open the wire harness clip [3], and remove the fuse
cable [4].
EXPLODED VIEW
NUT (8 mm) (2)
11 N·m (1.1 kgf·m, 8 lbf·ft)
WASHER (8 mm)
STARTER
CABLE (+)
BOLT
(8 x 18 mm)
INSTALLATION
Connect the fuse box 5P connector [1].
Set the fuse box 5P connector to the ECM bracket [2].
Route the fuse cable [3] and close the harness clip [4].
Install the ECM (page 10-3).
10-8
FUSE CABLE
TERMINAL COVER
STARTER
STARTER CABLE
CABLE (-)
HOLDER
[2]
HARNESS CLIP
[2]
[3]
[4]
[1]
NEUTRAL SWITCH
BRACKET
FUSE CABLE 1P
CONNECTOR
[4]
[3]
[1]