TOHATSU BFT75A Service Manual page 375

dummyhead dummyhead
CYLINDER HEAD
Disconnect breather tube [1] from the cylinder head
cover [2].
Remove the nine bolts [3], and remove the cylinder
head cover.
• Oil leaks out when the cylinder head cover is
removed. Catch the leaking oil with a shop towel and
a suitable container, and wipe up any spilled oil.
Disconnect the oil tube and remove the head cover
gasket from the cylinder head cover.
• Check the head cover gasket for damage and deterioration, and replace if necessary.
[3]
INSTALLATION
Clean the groove of the cylinder head cover [1], and
clean the head cover gasket [2].
Install the head cover gasket on the cylinder head
cover.
14-16
[1]
[2]
[2]
[1]