TOHATSU BFT75A Service Manual page 494

dummyhead dummyhead
Pass the trim angle sensor wire [1] and the power tilt
motor wire [2] through the motor wire bushing [3] in the
positions shown.
Install the motor wire bushing in the L. stern bracket,
aligning the projection [4] on the motor wire bushing
with the concave [5] in the L. stern bracket.
• Check that the trim angle sensor wire is on the right
side of the power tilt motor wire by viewing from the
backside of the L. stern bracket.
Install the wire harness clip [1] on the L. stern bracket
[2].
Check that the corrugated tube [3] on the power tilt
motor wire stands erect as shown.
Install the power tilt motor wire, aligning the end of the
taped part [4] of the power tilt motor wire with the end
[5] of the motor wire bushing.
Wind the spiral tube [6] onto the trim angle sensor wire
[7] and the power tilt motor wire so the end of the spiral
tube aligns with the end of the taped part [8] of the
power tilt motor wire.
Close the wire harness clip on the spiral tube.
Apply marine grease to the inner wall and outer surface
of the upper cylinder bushings [1] and install them on
the piston rod [2] of the power trim/tilt.
Apply marine grease to the outer surface of the upper
cylinder pin [3].
Align the hole in the piston rod with the hole in the
swivel case [4] and insert the upper cylinder pin into the
hole.
Install the E-rings [5] to the groove on the outer end of
the upper cylinder pin.
[5]
[3]
<Viewing L. stern bracket from the backside>
Up (engine side)
[3]
Rear
[1]
[6]
[4]
[5]
[5]
[5]
[3]
[2]
TRIM/TILT
[4]
[1]
[2]
[8]
[2]
[7]
[3]
[4]
[1]
18-13