TOHATSU BFT75A Service Manual page 493

dummyhead dummyhead
TRIM/TILT
While pushing the L./R. stern brackets lightly toward the
swivel case side, install the bolt [1] and the washer [2],
and loosely tighten the self-locking nut (10 mm) [3].
Install the trim angle sensor [1] and tighten the two bolts
[2].
Tighten the self-locking nut (7/8-14 UNF) [1] to the
specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Tighten the self-locking nut (25 x 2.0 mm) [2] to the
specified torque so that the tilting shaft end is flush with
the nut end.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Tighten the self-locking nut (Bolt 10 x 235 mm side).
Apply marine grease to the threads of both sides of the
tilting shaft.
Install the tilting bolt cap [3].
18-12
[1]
[2]
[3]
[2]
[1]
[2]
[3]
[1]