TOHATSU BFT75A Service Manual page 445

dummyhead dummyhead
GEAR CASE
INSTALLATION
Apply soapy water to the outer circumference of new
water seals [1].
Drive the water seals one by one into the shift rod
holder [2] using the special tool. Note the installation
direction of the water seals.
Be sure to apply marine grease to the water seal mating
surfaces before installation.
TOOL:
Installer/remover,
14.5 x 18.5 mm [3]
After installing the water seals, apply marine grease to
the water seal lips.
Install the E-ring [1], washer [2], and the shift rod spring
[3] on the shift rod [4].
16-16
[1]
07ZPF-ZW90300
[1]
[2]
[2]
[4]
[3]
[1]
[3]