TOHATSU BFT75A Service Manual page 554

dummyhead dummyhead
SLIDING PLATE
FAST IDLE SPRING
FAST IDLE WHEEL
FAST IDLE DETENT
ROLLER (13 X 13 mm)
SCREW (5 X 10 mm)
2.5 N·m (0.26 kgf·m, 1.8 lbf·ft)
SPRING
SETTING PLATE
FAST IDLE DETENT
SPRING (12.7 X 23.9 mm)
WASHER (6 mm)
PIN (6 X 6 mm)
INSTALLATION:
Install in the concave area of the
control wheel as shown.
SCREW
(5 X 10 mm)
WASHER (5 mm)
E-CLIP (4 mm)
E-CLIP (7 mm)
WASHER (6 mm) (2)
WASHER (8 mm)
SLIDING PLATE/PLATE COLLAR
INSTALLATION:
Install the sliding plate with the "UP"
mark facing up.
Attach the sliding plate collar to the
sliding plate with its wider side toward
the "UP" mark of the sliding plate.
PLATE COLLAR
CONTROL WHEEL
CONTROLS
LINK JOINT
BRACKET
NUT (5 mm)
4.9 N·m (0.50 kgf·m,
3.6 lbf·ft)
BOLT
(5 X 16 mm)
SCREW (6 X 10 mm)
5.9 N·m (0.60 kgf·m,
4.4 lbf·ft)
LINK JOINT ARM
LINK JOINT
COLLAR (2)
"UP" MARK
SLIDING PLATE
19-17