Flywheel Inspection; Neutral Switch Inspection - TOHATSU BFT75A Service Manual

dummyhead dummyhead
STARTING SYSTEM
STARTER SOLENOID
Check for continuity between the S terminal and front
bracket.
If there is no continuity, replace the starter solenoid.
Check for continuity between the S terminal and M
terminal.
If there is no continuity, replace the starter solenoid.

FLYWHEEL INSPECTION

Check the ring gear [1] for wear and damage.
If it is worn or damaged, check the pinion gear of the
starter motor.
Replace the flywheel or starter motor pinion gear, if
necessary.

NEUTRAL SWITCH INSPECTION

Remove the engine cover.
Release the neutral switch 2P connector [1] from the
connector holder and disconnect the connector.
Attach the tester leads to the two connector terminals at
the neutral switch.
Continuity should exist between the each position as
follows:
SWITCH PUSHED
(Shift lever in "N")
SWITCH RELEASED
(Shift lever in "F" or "R")
If the continuity is abnormal, check the following and
replace if necessary:
• Control lever is in the "N" (Neutral) position.
Tip [2] of the neutral switch is set in the detent
assisted spring [3] securely.
• The detent spring roller [4] is set in the groove [5] in
the shift arm.
9-22
[4]
Continuity
No continuity
[1]
[5]
[3]
[5]
[4]
[2]
[1]
[2]
[3]