TOHATSU BFT75A Service Manual page 506

dummyhead dummyhead
Remove socket bolt A (8 x 84 mm) [1], two socket bolts
B (8 x 23 mm) [2], and the pump [3]. Remove the five O-
rings [4] and orifice collar [5] from the cylinder [6].
Remove the reservoir valve [7] from the cylinder.
• Take care not to lose the pins and steel balls in the
reservoir valve.
Remove the internal circlip [1] and manual valve [2]
from the pump [3].
Check the manual valve and O-ring for deterioration,
wear, and damage.
Replace the manual valve with a new one if necessary.
Hold the cylinder [1] in a vise [2] with a shop towel or
soft jaws as shown.
Do not tighten the vise excessively, as it can damage
the cylinder.
• Make sure the right and left piston rod B are fully
extended.
• Do not push piston rod B into the trim cylinder.
Remove the rod guide [1] using the special tool as
shown.
TOOL:
Trim cap wrench, 4 mm [2]
[1]
[1]
[2]
[1]
070PA-001A100
[6]
[7]
[4]
[3]
[2]
[3]
[2]
[1]
[2]
TRIM/TILT
[5]
18-25