TOHATSU BFT75A Service Manual page 546

dummyhead dummyhead
Remove the snap pin [1] and remove the shift arm [2]
from the sift shaft.
• Remove the snap pin with care not to move the shift
arm out of the "N" (Neutral) position.
Release the neutral switch 2P connector [1] from the
neutral switch bracket [2] and disconnect the connector.
Remove the harness band clip [3] that clamps the fuse
cable from the neutral switch bracket.
Remove the bolt [4] from the neutral switch bracket, and
remove the neutral switch bracket.
Remove clip A [1] from the neutral switch bracket [2].
Remove the nut [3] from the neutral switch [4]. Remove
the neutral switch from the neutral switch bracket.
[1]
[2]
[4]
[2]
[3]
CONTROLS
[1]
[2]
[3]
[4]
[1]
19-9