TOHATSU BFT75A Service Manual page 88

dummyhead dummyhead
ADJUSTMENT
THROTTLE ARM NOT IN FULL OPEN POSITION
1. Loosen the shift pivot lock nut [1] of the remote
control cable (throttle side) [2] and remove the shift
pivot [3] from the throttle arm link pin [4].
2. Screw in the shift pivot until the throttle arm comes in
contact with the full open stopper and loosely install
the shift pivot on the throttle arm.
3. Remote control type:
Set the control lever in the full open position (page 3-
9).
Tiller handle type:
Align the "
open position of the throttle mark (page 3-9).
4. Check that steps 1, 2 and 3 of the throttle control
cable check are satisfied (page 3-10).
If steps 1, 2 and 3 of the throttle control cable
adjustment are not satisfied, adjust the throttle
control cable again starting with step 1.
If the throttle arm is in contact with the full open
stopper but steps 2 and 3 are not satisfied, go to the
procedure <Throttle cam not in full open position>.
5. Remote control type:
Move the control lever in the "N" (Neutral) position,
and tighten the shift pivot lock nut securely.
Tiller handle type:
Move the throttle grip to the full close position and
the gear shift lever in the "N" (Neutral) position, and
tighten the shift pivot lock nut securely.
THROTTLE CAM NOT IN FULL OPEN POSITION
Adjust the throttle control cable with it connected to the
throttle arm.
1. Remove the throttle rod linkage pivot [1] from the
throttle plate [2] and loosen the linkage pivot lock nut
[3].
2. While holding the throttle arm in contact with the full
open stopper, adjust the clearance between the
throttle cam and the stopper (full open side) to 1 mm
or less by turning the throttle rod linkage pivot.
3. Loosely install the linkage pivot on the throttle plate.
4. Check that steps 1, 2 and 3 of the throttle control
cable check are satisfied (page 3-10).
5. Tighten the linkage pivot lock nut.
6. After tightening the lock nut, check that the throttle
cam side pivot of the throttle rod is not out of the
throttle cam.
" mark on the throttle grip with the full
[4]
[3]
[1]
[3]
[3]
[2]
MAINTENANCE
[2]
[1]
[1]
3-11