Steering Rod Removal/Installation (Remote Control Type) - TOHATSU BFT75A Service Manual

dummyhead dummyhead
CONTROLS
SEAL HOLDER WATER SEAL REPLACEMENT
Remove the seal holder (page 19-12).
Remove the water seal (14 X 26 X 6 mm) [1] from the
seal holder [2] using the commercially available oil seal
remover.
Apply soapy water to the circumference of a new water
seal (14 X 26 X 6 mm), and install it on the seal holder.
• The marked side of the water seal is faces the seal
holder.
Apply marine grease to the water seal lip.
Install the seal holder (page 19-12).
STEERING ROD REMOVAL/INSTALLATION (REMOTE CONTROL
TYPE)
BOLT (3/8-24 UNF)
22 N·m (2.2 kgf·m, 16 lbf·ft)
STEERING ROD COLLAR
STEERING ROD
19-14
STEERING CABLE
(Commercially available)
WASHER (10 mm) (3)
[2]
TILTING BOLT CAP
SELF-LOCKING NUT (3/8-24 UNF) (2)
22 N·m (2.2 kgf·m, 16 lbf·ft)
[1]