TOHATSU BFT75A Service Manual page 418

dummyhead dummyhead
Apply soapy water to the outer surface of a oil seal [1].
Using the special tools as shown, install the oil seal on
the cylinder block assembly as shown.
Drive in the oil seal so its upper side is 1.0 to 2.0 mm
(0.04 to 0.08 in) deep from the surface.
TOOLS:
Driver [2]
Oil seal drier [3]
Apply grease to the lip of the oil seal.
• Install the oil seal with the lip in the direction shown.
Install the following parts.
– Flywheel (page 9-9)
– Cylinder head (page 14-20)
– ECT sensor 2(page 5-85)
– EOP sensor (page 5-84)
– Knock sensor (page 5-84)
– EBT sensor (page 5-84)
– Electronic parts case (page 10-3)
– Starter motor (page 9-6)
– Air vent strainer/air vent tube (page 5-86)
– Intake manifold/throttle body (page 5-71)
– Fuel strainer (low pressure side) (page 3-25)
– Oil filter cartridge (page 3-5)
Install the engine on the outboard motor (page 13-8).
07749-0010000
07ZAD-PNAA100
1.0 - 2.0 mm
(0.04 - 0.08 in)
CYLINDER BLOCK
[3]
[1]
15-17
[2]