TOHATSU BFT75A Service Manual page 500

dummyhead dummyhead
ASSEMBLY
Install the detent assist spring [1], detent spring [2], and
bolt [3]; tighten the bolt.
Apply marine grease to the detent spring roller.
Apply marine grease to the circumference of the tilt
stoppers [4] and tilt arm bushings [5].
Apply marine grease to the tilting bracket cam [6].
Install the two tilt arm bushings to the swivel case [7],
and then install the tilt stoppers and tilting bracket.
Check that the projection [1] of the tilting bracket is in
the position shown.
Using a commercially available pin driver (2.5 mm) [2],
drive the spring pins (2.5 X 20 mm) [3] into the tilting
bracket until the pins protrude by 1.0 – 2.0 mm (0.04 –
0.08 in) from the other side of the tilting bracket as
shown.
• Do not drive in the spring pins excessively, or the tilt
stopper cannot operate properly.
Install the two thrust receivers [1], washers [2], and self-
locking nuts [3] to the swivel case [4] and tighten the
self-locking nuts.
Apply marine grease to the sliding surface of the thrust
receivers.
Install the three grease fittings [5] on the swivel case,
and tighten them to the specified torque.
TORQUE: 3 N·m (0.31 kgf·m, 2.2 lbf·ft)
[3]
[1]
[2]
[7]
[5]
[4]
[2]
[1]
1.0 – 2.0 mm (0.04 – 0.08 in)
[5]
[1]
[5]
TRIM/TILT
[6]
[5]
[4]
[3]
[4]
[3]
[2]
18-19