TOHATSU BFT75A Service Manual page 514

dummyhead dummyhead
Apply ATF to five new O-rings [1] and orifice collar [2].
Install the reservoir valve [3] into the cylinder [4].
• Note the installation direction of the reservoir valve.
• Take care not to let the pin and steel ball come out
of the reservoir valve.
Install the five O-rings and orifice collar in the cylinder
and install the pump [5] on the cylinder.
Install and tighten socket bolts A [6] and B [7] to the
specified torque.
TORQUE: 8.3 N·m (0.85 kgf·m, 6.1 lbf·ft)
Fill the pump [1] fully with fresh ATF.
Do not fill up the pump quickly. Pour ATF in the pump
slowly.
Install filter B [1] and the drive joint [2] on the pump [3].
Pump side:
[3]
[1]
[5]
[6]
[7]
[1]
[2]
[1]
TRIM/TILT
Cylinder side:
[3]
[4]
[2]
[3]
18-33