dummyhead
dummyhead
While watching pressure tester gauge [1], apply the
specified air pressure to the gear case by pumping the
handle slowly.
Do not apply excessive air pressure.
AIR PRESSURE:
0.029 MPa (0.3 kgf/cm
While applying the specified air pressure to the gear
case, move the shift rod [1] right and left five or six
times using pliers.
• Wrap a shop towel [2] around the shift rod spline to
move the shift rod with pliers.
While applying the specified air pressure to the gear
case, turn the vertical shaft [1] five or six turns
clockwise.
Be sure to turn the vertical shaft clockwise, or damage
to the water pump impeller can occur.
While applying the specified air pressure to the gear
case, turn the propeller shaft [1] right and left two or
three turns.
Leave the gear case for five minutes and then check
that the air pressure is maintained.
2
, 4.3 psi)
GEAR CASE
[1]
[1]
[1]
[2]
[1]
16-43