TOHATSU BFT75A Service Manual page 404

dummyhead dummyhead
CRANKCASE/CRANKSHAFT/
CYLINDER BLOCK/PISTON
DISASSEMBLY/ASSEMBLY
CRANKCASE/CRANKSHAFT/
CYLINDER BLOCK DISASSEMBLY
Store the removed parts (e.g. bearings, connecting
rods, rod caps, bolts) securely, grouping them for each
cylinder.
Move the shift to the "N" (Neutral) position.
Remove the engine from the outboard motor (page 13-
3)
Remove the following parts.
– Oil filter cartridge (page 3-5)
– Fuel strainer (low pressure side) (page 3-25)
– Intake manifold/throttle body (page 5-69)
– Air vent strainer/air vent tube (page 5-86)
– Starter motor (page 9-5)
– Electronic parts case (page 10-3)
– EBT sensor (page 5-84)
– Knock sensor (page 5-84)
– EOP sensor (page 5-84)
– ECT sensor 2(page 5-85)
– Cylinder head (page 14-19)
– Flywheel (page 9-8)
Turn the alternator rotor clockwise until it sets the No.1
piston at top dead center of its compression stroke
(page 3-12).
Remove the two bolts [1] from the crankcase and
remove the oil filter extension [2] and O-ring [3].
Remove the two bolts [1] from the flywheel side of the
crankcase
CYLINDER BLOCK
[2]
[3]
[1]
[1]
15-3