TOHATSU BFT75A Service Manual page 513

dummyhead dummyhead
TRIM/TILT
Apply marine grease to the rod guide threads [1].
Install the rod guide on piston rod B [2].
Extend piston rod B fully and hold it in that position.
Set one piston rod B in the left cylinder chamber and
one in the right cylinder chamber.
Do not install either piston rod B by pushing it into the
trim cylinder.
Holding each piston rod B in place, loosely tighten the
rod guides on the cylinders.
Do not install either piston rod B by pushing it into the
trim cylinder.
Using the special tool, tighten the left and right rod
guides [1] to the specified torque as shown.
TOOL:
Trim cap wrench, 4 mm [2]
TORQUE: 139.5 N·m (14.2 kgf·m, 103 lbf·ft)
• Make sure the torque wrench [3] stays perpendicular
[4] to the special tool. If the torque wrench is not held
90 degrees to the tool, the torque reading will be
incorrect.
Apply ATF to the manual valve O-rings [1].
Install the manual valve [2] to the pump [3] and tighten it
to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Install the internal circlip [4].
18-32
070PA-001A100
[2]
[4]
[2]
[1]
[3]
[1]
[3]
[4]
[3]
[2]
[1]
[2]