TOHATSU BFT75A Service Manual page 579

dummyhead dummyhead
CONTROLS
Install the combination switch [1] on the tiller handle [2],
aligning the cutout [3] in the combination switch with the
flat part [4] in the switch installation part of the tiller
handle as shown.
Install the emergency stop switch [5] on the tiller
handle, aligning the cutout [6] in the emergency stop
switch with the flat part [7] in the switch installation part
of the tiller handle as shown.
Install the connector bracket [1] and bolt [2], and tighten it to the specified torque.
TORQUE: 7 N·m (0.71 kgf·m, 5.2 lbf·ft)
Install tube A [3] and set the harness band clips [4] to the connector bracket.
19-42
[4]
[2]
[1]
[5]
[4]
[1]
[3]
[2]
[3]
[4]
[2]
[6]
[7]