TOHATSU BFT75A Service Manual page 515

dummyhead dummyhead
TRIM/TILT
After installation, check filter B for bubbles. Remove the
bubbles with an oil bottle [1] or an equivalent tool if
necessary.
Be sure to remove the air bubbles, or they will cause air
in the system.
After removing the air bubbles, fill the pump fully with
ATF again.
Apply ATF to a new O-ring [1] and install it on the power
tilt motor [2].
Install the power tilt motor on the pump by aligning the
projection [1] on the motor with the cutout in the drive
joint [2].
Set the motor wire of the power tilt motor facing toward
the manual valve side.
Tighten the four power tilt motor mounting bolt/washers
[4] to the specified torque.
TORQUE: 4.9 N·m (0.50 kgf·m, 3.6 lbf·ft)
18-34
[1]
[2]
[3]
[1]
[2]
[1]