TOHATSU BFT75A Service Manual page 443

dummyhead dummyhead
GEAR CASE
Attach the lead wire [1] to the extension case [2], and
tighten the bolt [3].
Install the lower mount housing [4] on the extension
case, and tighten the three bolt/washers [5].
Remove the engine hangar chain from the engine
hangers, and lower the outboard motor to the
lowermost position.
Install the following:
– Gear/case/extension separator (XRT type only)
(page 16-7)
– L./R. engine under cover(page 6-7)
– Engine cover
SHIFT ROD REMOVAL/INSTALLATION
REMOVAL
Remove the following:
– Gear case (page 16-5)
– Water pump (page 11-6)
Wrap a shop towel [1] around the shift rod spline, and
use pliers to turn the shift rod [2] in the direction shown
(toward the reverse side).
Remove the bolt [1], washer [2], and shift rod holder [3].
Remove the shift rod [4].
16-14
[2]
[5]
[4]
[2]
[4]
[1]
[2]
[1]
[3]
[1]
[3]