TOHATSU BFT75A Service Manual page 512

dummyhead dummyhead
Apply ATF to a new O-ring [1] and new backup ring [2],
and install them on piston rod B [3].
• Install the backup ring on piston rod B with care not
to break it.
Apply ATF to a new oil seal [1].
Holding the oil seal in the shape of a "U" with your
fingers, install it in the lower groove in the rod guide [2],
taking care not to damage the oil seal.
Apply ATF to a new dust seal [3].
Holding the dust seal in the shape of a "U" with your
fingers, install it in the upper groove in the rod guide,
taking care not to damage the dust seal.
Apply ATF to a new O-ring [4] and install it on the rod
guide.
[3]
[2]
[1]
Push in at an angle.
[1]
Hold in the shape "U".
[2]
TRIM/TILT
[3]
[1]
[2]
[4]
Push i by deforming
it slightly.
[3]
[4]
[1]
18-31