Vertical Shaft/Forward Bevel Gear Removal/Installation - TOHATSU BFT75A Service Manual

dummyhead dummyhead
VERTICAL SHAFT/FORWARD BEVEL
GEAR REMOVAL/INSTALLATION
REMOVAL
Remove the following:
– Propeller (page 16-3)
– Gear case (page 16-5)
– Water pump (page 11-6)
– Shift rod (page 16-14)
– Propeller shaft holder (page 16-18)
Attach the special tool to the vertical shaft end
(Flywheel installation side) [1].
TOOL:
Vertical shaft holder [2]
Place a shop towel or equivalent [3] to protect the gear
case. [4]
Holding the vertical shaft with the special tool, remove
the pinion gear nut [5] from the vertical shaft.
Remove the lock nut using the special tool as shown.
TOOL:
Lock nut wrench, 30/64 mm [1]
Remove the vertical shaft [1] and pinion gear [2].
Remove the forward bevel gear/taper bearing [3].
[1]
07SPB-ZW10200
[5]
07916-MB00002
GEAR CASE
[2]
[4]
[3]
[1]
[1]
[2]
[3]
16-25