TOHATSU BFT75A Service Manual page 523

dummyhead dummyhead
TRIM/TILT
Pull the brushes [1] from the brush holders and remove
the two brush springs [2].
Disconnect the motor wire (Blue wire) terminal [3] from
the breaker [4] while holding the breaker with a
screwdriver.
• Do not disconnect the Blue wire terminal without
holding the breaker, or it can cause damage to the
breaker. Be sure to disconnect the terminal while
holding the breaker.
• Take care not to touch the bimetal part of the
breaker during removal.
Remove the two screws (4 x 10 mm) [5], brush terminal
[6], motor wire (Green wire) [7], brush holders A [8] and
B [9], and breaker.
Remove the O-ring [10] from the front bracket groove.
Check the oil seal [11] for damage or wear.
Replace the oil seal with a new one if necessary.
Check the metal part [12] of the front bracket for
damage and wear.
Replace the front bracket assembly if necessary.
18-42
[1]
[9]
[5]
[3]
[10]
[3]
[12]
[4]
[6]
[8]
[5]
[7]
[6]
[5]
[7]
[2]
[11]