Gear Case Oil Change - TOHATSU BFT75A Service Manual

dummyhead dummyhead
MAINTENANCE
Apply clean engine oil to the O-ring [1] and threads [2]
of a new oil filter.
Clean the filter mounting base, and coat the stud with
clean engine oil.
• Use only a Honda Genuine oil filter or a filter of
equivalent quality specified for your model. Using
the wrong Honda filter, or a non-Honda filter that is
not of equivalent quality, may cause engine
damage.
Screw on the filter [1] by hand first, and then screw it in
to the specified torque using the special tool used for
removing the filter.
TOOL:
Oil filter wrench, 65 mm
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Refill the engine with the specified amount of the
recommended oil as described in the oil change
procedure (page 3-5), and start the engine to warm it up
to the normal operating temperature.
Stop the engine and check for leaks from the oil filter.
Check the oil level (page 3-4).
Install the engine cover.

GEAR CASE OIL CHANGE

INSPECTION
Remove the oil check bolt [1] and check whether gear
case oil flows out of the gear case.
Catch the oil in a suitable container.
If oil does not flow out, add oil (page 3-8).
Coat a new O-ring [2] with a clean gear oil and set it on
the oil check bolt.
Install the oil check bolt in the gear case and tighten the
bolt to the specified torque.
TORQUE: 6.5 N·m (0.66 kgf·m, 4.8 lbf·ft)
3-6
07AAA-PLCA100 or
07HAA-PJ70101
[2]
[1]
[1]
[1]
[2]