TOHATSU BFT75A Service Manual page 544

dummyhead dummyhead
Connect the 14P connector [1] and 6P connector [2] to
the engine side connectors [3] and secure the
connectors to the connector holders [4].
Install the remote control cable plate [5] and tighten the
bolt [6].
Secure the 14P connector wire harness [7] and 6P
connector wire harness [8] with the new harness band
clip [9] and install it to the remote control cable plate.
After securing the 14P/6P connector wire harness, cut
off the excess of the band so it does not interfere with
the neighboring parts.
Route the throttle control cable [1] and shift control
cable [2] through the cable grommet [3].
Align the groove [4] in the remote control cables (shift
and throttle) with the groove [5] in the remote control
cable plate.
Install the remote control cable cover [6] on the remote
control cable plate with the projection [7] on the remote
control cable cover set in the cutout [8] in the remote
control cable plate.
Tighten the bolt [9].
Install the lock nuts [10] and shift pivots [11] on the
remote control cables.
Apply marine grease to the link pin installation port of
the shift pivot.
Connect the shift pivots to the shift link pin [12] and the
throttle arm link pin [13]. (Slide the lock plates [14] to
connect the remote control cables and lock.)
[1]
[8]
[7]
[6]
[5]
[4]
[2]
[3]
[14]
[11]
[10]
[14]
[13] [12]
[5]
[8]
CONTROLS
[3]
[2]
[9]
[1]
[9] [6]
[4]
[7]
19-7